Hello everyone

Post to this forum to introduce yourself to this forum if you are new here. You might want to include some information about the work you are doing or planning to do with QCAD.

Moderator: andrew

Post Reply
IanT
Registered Member
Posts: 1
Joined: Wed Sep 16, 2020 12:24 pm

Hello everyone

Post by IanT » Wed Sep 16, 2020 12:35 pm

I’m pretty new to QCAD, I have purchased it as an alternative to Draftsight. I mainly use it to manipulate/inspect DXF output from SketchUp prior to CAM. It’s important to me that it is capable of saving earlier version DXF for older CAM to read.

I hadn’t heard of this software before, but have to say I’m very impressed with it. Because if the limited case use I have, I guess I won’t be an expert or power user, but it’s been a nice stable experience so far.

Ian in England.
Top
User avatar
andrew
Site Admin
Posts: 8791
Joined: Fri Mar 30, 2007 6:07 am

Re: Hello everyone

Post by andrew » Thu Sep 17, 2020 10:16 am

Welcome to the QCAD forum and thanks for your feedback!
Top
Post Reply

Return to “Introduce Yourself”