QCAD.org Forum

I’m pretty new to QCAD, I have purchased it as an alternative to Draftsight. I mainly use it to manipulate/inspect DXF output from SketchUp prior to CAM. It’s important to me that it is capable of saving earlier version DXF for older CAM to read.

I hadn’t heard of this software before, but have to say I’m very impressed with it. Because if the limited case use I have, I guess I won’t be an expert or power user, but it’s been a nice stable experience so far.

Ian in England.

Welcome to the QCAD forum and thanks for your feedback!